close
close
How To Fix A Maytag Washer That Won't Start

How To Fix A Maytag Washer That Won't Start

How To Fix A Maytag Washer That Won't Start

How To Fix A Maytag Washer That Won't Start. If your washer isn’t plugged in, it’s likely that you’ll need to reset the outlet. If it does not recognize both water supply hoses are turned on, the control detects a problem with the water pressure sensor.

How To Fix A Maytag Washer That Won't StartHow To Fix A Maytag Washer That Won't Start
Maytag neptune MAH5500BWW won't start Applianceblog Repair Forums from www.applianceblog.com

Press and hold the power/start button for 5 seconds. Fasten the mounting bolt located on the motor's opposite side. To determine if the line fuse is at fault, use a multimeter to test it for continuity.

Please Make Sure Both Inlet Hoses Are Connected, And Both Hot And Cold Water Supplies Are Turned On.

If there are tears in the seal, it will need to be replaced. In addition, you should investigate and resolve the problem that caused the fuse to. Line up the bolt holes and tighten the mounting bolts.

If The Problem Persists, Check If Something Is Lodged Under The Door Seal By Gently Pulling It Back.

The line fuse may blow if the washer circuits are overloaded, which will cause it not to turn on. When your maytag washer turns on but won’t start there may be a problem with the door closure. Pull against the motor to create tension on the belt, then tighten the rear motor mounting bolt.

See also  Phopollo Led Strip Lights App Download

Check The Door For Trapped Clothing That May Prevent It From Closing Completely.

Do not use an extension cord. That is likely the issue because washers use a decent amount of power. You will have to apply slight pressure to the areas around the start button.

If The Fuse Does Happen To Blow, It’s Probably Due To A Lack Of Power.

Reconnect all hoses and snap in clamps. As a safety precaution, the washer won’t start if the door isn’t properly shut and latched. Do not remove a ground prong.

If So, Reset The Circuit Breaker Or Ground Fault Circuit Interrupter.

Wipe it down with a damp cloth to remove any dirt or debris. Should the lid switch be damaged, the washer will stop halfway through the cycle. Check first to see if it’s plugged in.

Leave a Reply

Your email address will not be published.